问答中心 › 作者 "andy"
Filter:QuestionsSubscribes
射孔文件中输入的射孔井段是带补心高的，此时是否需要校正深度？
已解决Andy 提问于 5年 ago • 
292 views1 answers0 votes
在builder中加入新井时，导入完井轨迹、射孔和生产数据后点击校验，提示Error for well 'K103H': – model well completions required.请问该如何解决呢？
回答Andy 提问于 6年 ago • 
546 views1 answers0 votes
导入井轨迹文件时提示：Warning, measured depth has not been input for well K103H. Therefore, it has been calculated assuming straight lines between points. This calculation may result in incorrect measured depth values for deviated or horizontal wells.
回答Andy 提问于 6年 ago • 
473 views1 answers0 votes